Manual Tuning - Aiwa CA-DW630 Operating Instructions Manual

MANUAL TUNING
1
TUNER
MODE/OSC
1 Press the TUNER/BAND button repeatedlyto
select the desired band.
r--FM-AMl
2 Press the+ DOWN or - UP button to
select a station.
Each time the button is pressed, the frequency changes.
During FM stereo reception, "STEREO" is displayed.
To play a tuned station when the power is off (Direct
Play Function)
Press the TUNER/BAND button on the main unit. The power
is turned on and the tuned station is played.
To search for a station quickly (Auto Search)
Keep the 4+ DOWN or - UP button pressed until the
tuner starts searching for a station. After tuning in to a
station, the search stops.
To stop the Auto Search manually, press the ++ DOWN or
* UP button.
The Auto Search may not stop at stations with very weak
signals.
For better reception
FM
Extend the FM antenna and orient it for the best reception.
AM
The AM antenna is inside the unit. Position the unit for the
best reception.
When an FM stereo broadcast contains noise
Press the TUNER MODE/OSC button.
"MONO" appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, press the button again.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step.
If you use this unit in an area where the frequency allocation
system is 9 kHz/step, change the tuning interval.
Press the POWER button while pressing the TUNER/BAND
button.
To reset the interval, repeat this procedure.
NOTE
When the AM tuning interval is changed, all preset stations
(see "PRESETTING STATIONS") are cleared. The preset
stations have to be set again.
*
#FM
L
$
6
ENGLISH