General; Care And Maintenance; Specifications - Aiwa CA-DW630 Operating Instructions Manual

CARE AND MAINTENANCE
SPECIFICATIONS
Occasional care and maintenance of the unit and the
software are needed to optimize the performance of your
unit.
To clean the cabinet
Use a soft and dry cloth.
If the surfaces are extremely dirty, use a soft cloth lightly
moistened with mild detergent solution. Do not use strong
solvents, such as alcohol, benzine or thinner as these could
damage the finish of the unit.
To clean the heads and tape paths
After every 10 hours of use, clean the heads and tape paths
with a head cleaning cassette or cotton swab moistened with
cleaning fluid or denatured alcohol. (These cleaning kits are
commercially available.)
When cleaning with a cotton swab 0, wipe the recording/
playback head Q, erasure head 0, capstans ~, and
pinchrollers Q.
After cleaning the heads and tape paths with a liquid head
cleaning cassette or a moistened swab, wait until the
cleaned parts are completely dry before inserting tapes.
Care
of discs
When a disc becomes dirty, wipe the disc from the center
out with a cleaning cloth.
After playing a disc, store the disc in its case. Do not leave
the disc in places that are hot or humid.
Care of
tapes
Store tapes in their cases after use.
Do not leave tapes near magnets, motors, television sets,
or any source of magnetism. This will downgrade the
sound quality and cause noise.
Do not expose tapes to direct sunlight, or leave them in a
car parked in direct sunlight.
FM tuner section
Tuning range 87.5 MHz
to 108 MHz
Antenna Rod antenna
AM tuner section
Tuning range 530
kHz to 1710 kHz (1O kHz step)
531 kHz to 1602 kHz (9 kHz step)
Antenna
Ferrite bar antenna
Cassette deck section
Track format
Frequency response
Recording system
Heads
4 tracks, 2 channels stereo
Normal tape: 50 Hz – 12500 Hz
AC bias
Recording/playback/erasure head x
1
Compact disc player section
Laser
Semiconductor laser (L= 780 nm)
D-A
converter
1 bit dual
General
Power output 5 W + 5 W (4 ohms, EIAJ)
FTC rule
4 Watts per channel, Min.
RMS at 4 ohms from 65 Hz to
15,000 Hz, with no more than 1
Y.
distortion
output PHONES (stereo minijack)
Power requirements DC 12 V using eight size D (R20)
batteries
AC 120 V, 60
HZ
Power consumption 30
w
Dimensions of main unit (W x H x D)
266 x 303.7x 275.5 mm
(10'/2x 12x 107/s in.)
Weight of main unit
4.3 kg (9 Ibs. 8 02)
Speaker
Type 120 mm cone type
27 mm ceramic type
Dimensions (W x H x D)
197 X 303.7X 240
(77/8 X12X 9'/, in.)
Weight 1.75 kg (3 lb. 14 OZ.) X 2
Impedance 4 ohms
Allowable max. input low
Specifications and external appearance are subject to
change without notice.
Specifications, trade mark and model name are marked on
the rear of the unit.
COPYRIGHT
Please check the laws on copyright relating to reccwdings
from discs, radio or external tapes for the country iln which
the machine is being used.
16
ENGLISH