Safety Notice - Microchip Technology Digital Power Starter Kit User Manual

 2012 Microchip Technology Inc.
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
DIGITAL POWER STARTER KIT

Safety Notice

The following safety notices and operating instructions should be adhered to avoid a
safety hazard. If in any doubt, consult your supplier.
DANGER – The Digital Power Starter Kit contains two resistive loads that are intended
to dissipate power in the form of heat. Depending on the output power level, it is pos-
sible for the resistive load to become hot to the touch or to any surface in direct contact
with the board.
WARNING – The Digital Power Starter Kit should only be installed, operated, serviced
or modified by qualified personnel. Any service or modification performed by the user
is done at the user's own risk and voids all warranties.
CAUTION – Particular care should be taken during code development as unexpected
voltage regulation behavior is possible. Ensure that the power supply connected to the
Digital Power Starter Kit is properly protected against overcurrent event caused by
code development.
General Notices:
• The Digital Power Starter Kit is intended for evaluation and development purposes
and should only be operated in a normal laboratory environment as defined by
IEC 61010-1:2001.
• Clean with a dry cloth only.
• Operate flat on a bench away from any surface items that might become in con-
tact with the board. Do not move during operation and avoid direct contact with
the bottom layer of the board.
• The Digital Power Starter Kit should not be connected or operated if there is any
apparent damage to the unit.
USER'S GUIDE
DS52078A-page 5