Advertisement
1.
Use your hand to loosen and remove the air cap retaining ring
and air cap housing.
2. Test spray pattern and atomization while holding gun about 6
to inches (150 to 200 mm) from test piece.
.
3.
While triggering the gun, use your hand to loosen and remove the nozzle.
4.
Use your hand to loosen and remove the fluid knob assembly and
compression ring from the back of the gun and remove the old needle.
5.
Insert the needle assembly in the back of the gun. Reassemble nozzle, air cap housing and air cap re-
taining ring. Hand tighten.
Note: Nozzle should always have an o–ring (A).
6
309317
A
Advertisement
