Advertisement
PRESSURE RELIEF
sprayer
For Cup Guns
Follow these
instructions whenever
you stop spraying.
For Pressure Feed Guns
Follow these
instructions whenever
you stop spraying.
TIP SELECTION
A Tip consists of a fluid
nozzle, and fluid needle.
Use the following chart
for recommendations.
Installing the Fluid Set
Trigger the gun whenever you tighten or remove the nozzle. This keeps the needle seat away from
the nozzle seating surface and prevents the seat from being scratched.
– Follow this procedure when cleaning, repairing or shuting down
1. Turn off turbine.
1. Turn off air supply to the pot.
2. Open pressure relief (A) on
pot until pressure is completely
relieved. Close relief.
Fluid Set
Tip Size
#2
0.8 mm
244123
(0.032 in)
#3
1.3 mm
Water base lacquer, urethane, varnish, stain, and automotive finish.
244124
(0.051 in)
1.8 mm
#4
Lacquer, urethane, varnish, stain, primer, enamel and epoxy.
(0.071 in)
244125
2.2 mm
#5
Lacquer, urethane, varnish, stain, primer, enamel, epoxy and
(0.087 in)
244126
higher output industrial finishes.
#6
Latex, multi–spec, oil wall paint, industrial finishes, buty-
2.5 mm
244127
rate, and nitrate dope.
(0.098 in)
CAUTION
A
Fluid Usage
Ink, dye and non–wiping stain.
2. Unlatch cup
A
2 quart
02882
8069A
5
309317
Advertisement
