Table of Contents
Advertisement
Exit Without Saving
To exit without saving while in the main menu, press EXIT. The module returns to run mode
from configuration mode without saving any changes. This ends the configuration session
and the previous settings will remain in effect.
To return to the main menu from the sub-menu, press EXIT. You can move between the
two menus as much as you need to during any given configuration session.
If you exit from the main menu without saving, as described above, any changes made in the
sub-menu are not saved. If you save and exit from the main menu, changes made in the
sub-menu are saved as well.
IMPORTANT
Setting Factory Defaults
To reset all parameters in both menus to their factory defaults, press the VIEW and DATA
buttons simultaneously when in configuration mode. When this button combination is
pressed, the module displays the first parameter and its factory default.
To save the factory default parameters, press the VIEW and EXIT buttons simultaneously.
If you press only the EXIT button, the unit returns to run mode without changing the
parameters to their factory defaults.
Verifying the Communication Parameters
Before connecting the module to the network, cycle through the parameter settings and verify
that they are correct. Incorrect settings may cause unreliable and unpredictable operation of
the network.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
If the module is left inactive (i.e., with no buttons pressed) in
configuration mode for 3 minutes, it returns to run mode. Any changes
made since going into configuration mode will not be saved. Also, if
power to the unit is interrupted while in configuration mode, any
changes made will not be saved.
Configuring the Module
Publication 1770-UM520C-EN-P - July 2004
4-13
Advertisement
Table of Contents
