Filter Element For Snu Hot; Appliance Description; Standard Delivery; Accessories - STIEBEL ELTRON SNU HOT Installation Manual

INSTALLATION

Appliance description

2.3

Filter element for SNU HOT

Material losses
!
Hardness Total hard-
range ness
1 (weich) < 8.4 °dH
2 (mittel) 8.4 - 14 °dH
3 (hart) > 14 °dH
For trouble-free operation, the water should ideally be
in hardness range 1. This avoids any increased scaling in
the appliance. We recommend the installation of a water
softener; see "Accessories" chapter. It will improve the
water's taste, odour and appearance.
3. Appliance description
3.1

Standard delivery

The following are delivered with the appliance:
- Mounting bracket
- Kitchen tap
- Gaskets
- 2 strainers
- Offset connector with integral flow limiter
- Hose ferrule
- Hose retainer
- Fixing materials
3.2

Accessories

- Water filter system starter kit Basis, part no. 233231, with
cartridge, connection hose, wall mounting bracket and hard-
ness test strip
- Water filter system starter kit Komfort, part no. 233232, with
cartridge, connection hose, wall mounting bracket, hardness
test strip and one flow meter
- Filter cartridges (3 pce), order no. 233230
- Special aerator, part no. 298699
- Strainer, part no. 298700
www.stiebel-eltron.com
Total hardness Filter element
(sum of Ca + Mg)
< 1.5 mmol/l recommended
1.5 - < 2.5 mmol/l required
> 2.5 mmol/l required
4.

Preparations

f Flush the water line thoroughly. f
Water installation
A safety valve is not required.
Taps
f Only use the HOT 3in1 kitchen tap. f
Different taps are not permissible.
Water filter system
f Use the water filter system starter kit; see "Accessories" f
chapter.
4.1

Installation site

Material losses
!
Install the appliance in a room free from the risk of frost.
f Always install the appliance vertically and near the draw-off f
point.
The appliance is suitable for undersink installation only.
Material losses
!
The appliance must be fitted to a wall with sufficient
load-bearing capacity.
SNU HOT | HOT 3in1 | 13