CONTENTS | SPECIAL INFORMATION SPECIAL INFORMATION 15.7 Data table �������������������������������������������������������� 23 OPERATION GUARANTEE General information ��������������������������������������� 15 ENVIRONMENT AND RECYCLING Safety instructions ���������������������������������������������� 15 INSTALLATION TEMPLATE (IN THE MIDDLE OF THESE INSTRUC- Other symbols in this documentation ���������������������� 15 TIONS) Units of measurement �����������������������������������������...
OPERATION General information OPERATION Symbol Meaning Material losses (appliance damage, consequential losses and environmen- tal pollution) Appliance disposal General information The chapters "Special Information" and "Operation" are intended f This symbol indicates that you have to do something. The ac- for both the user and qualified contractors.
OPERATION Appliance description Operation Material losses The user should protect the appliance and its tap against You can set any required DHW outlet temperature at the tem- frost. perature selector. The heat-up indicator illuminates during the heat-up process. Material losses Never subject the appliance to water pressure.
OPERATION Troubleshooting INSTALLATION Troubleshooting Problem Cause Remedy The appliance does not The temperature se- Switch the appliance ON supply hot water. lector is set to “°C”. by turning the temperature Safety selector. No power at the ap- Check the plug / fuses in pliance.
INSTALLATION Preparations Preparations Installation f Flush the water line thoroughly. Appliance installation Water installation f Mark out the drill holes using the installation template (see middle part of these instructions). A safety valve is not required. f Drill the holes and insert suitable rawl plugs. Taps/valves f Secure the wall mounting bracket using suitable screws.
Observe the type plate. See chapter "Installation / Commissioning / Initial start-up". The following electrical connections are permissible: SNU 5 SL SNU 5 SLi SNU 5 SLi 1 kW Connection to a freely accessible standard socket with matching plug Permanent connection to an appliance junction box with earth conductor www.stiebel-eltron.com...
INSTALLATION Settings 11. Settings 14. Service 11.1 Setting the temperature limit WARNING Electrocution Before any work on the appliance, disconnect all poles of the appliance from the power supply. f Dismantle the appliance for maintenance work. 14.1 Draining the appliance WARNING Burns Hot water may escape during the draining process.
14.6 Replacing the power cable The power cable must only be replaced by a qualified contractor with an original spare part. Alternatively, the H05VV-F3x1.0 cable may be used. SNU 5 SL 1 kW SNU 5 SLi Appliance Height Appliance Width...
The test symbols can be seen on the type plate. 15.5 Extreme operating and fault conditions In the case of faults, a peak temperature of up to 100 °C may briefly occur in the system. SNU 5 SLi AUS 15.6 Details on energy consumption Appliance Height...
INSTALLATION Specification 15.7 Data table SNU 5 SL 1 kW SNU 5 SLi SNU 5 SLi AUS 221116 221121 229467 Hydraulic data Nominal capacity Mixed water volume 40 °C Electrical data Rated voltage V 220 230 240 220 230 240 220 230 240...
Page 12
Who gives the warranty where our subsidiaries sell our products a guarantee can only The warranty is given by Stiebel Eltron (Aust) Pty Ltd be issued by those subsidiaries. Such guarantee is only grant- (A.B.N. 82 066 271 083) of 6 Prohasky Street, Port Mel- ed if the subsidiary has issued its own terms of guarantee.
Page 13
The Stiebel Eltron warranty for the unit is in addition to any c) connection to water from a bore, dam or swimming rights and remedies you may have under the Australian pool;...