Connecting The Hot Water Boiler - STIEBEL ELTRON MEKD Administrator's Manual For Operation And Installation

INSTALLATION
Installation
6.3

Connecting the hot water boiler

3
2
1 Cold water connection
2 Connection to tap body
3 DHW connection
f If necessary shorten the connection pipes to the required
length and deburr the cut edges.
f Slacken off the union nuts of the threaded fittings at the con-
nections on the tap body.
f Insert the connection pipes vertically through the union nuts
into the connections on the tap body.
f Screw the connection pipes loosely to the tap body using the
union nuts.
f Fit the hot water boiler.
f Hand-tighten the connection pipes to the connections of the
hot water boiler using the O-rings and the union nuts.
22 | MEKD | MEBD
f With a spanner, apply a small amount of torque to tighten
the union nuts of the threaded fittings to the tap body.
MEKD only
f Screw the spout with O-ring onto the tap body until
1
finger-tight.
2
On a bath – MEBD only
f Screw the spout with O-ring onto the tap body until
finger-tight.
f Screw the retainer for the hand shower with O-ring onto the
spout until finger-tight.
f Screw the hose with O-ring onto the retainer for the hand
shower until finger-tight.
f Screw the hand shower with O-ring onto the hose until
finger-tight.
On a shower – MEBD only
f Screw the retainer for the hand shower with O-ring onto the
tap body until finger-tight.
f Screw the hose with O-ring onto the retainer for the hand
shower until finger-tight.
f Screw the hand shower with O-ring onto the hose until
finger-tight.
www.stiebel-eltron.com