Endless Pools FASTLANE POOL Owner's Manual page 22

P5/8/08
Once installed, your Fastlane Pool will provide years of swimming, exercise, training,
therapy and family fun with minimal maintenance.
The Fastlane
Clean the intake grill of the Fastlane Swim Unit of leaves as needed.
"
Wipe down the stainless steel grab bar with a Scotch Brite pad and brisk rubbing.
"
Clean the acrylic housing with any typical non-ammonia, non-abrasive kitchen
"
cleanser.
Periodically check all electrical and ground wire connections and test the GFI circuit
"
breaker for proper function.
The hydraulic motor, which is located in your Swim Unit and submerged underwater,
"
should be replaced after three years of usage.
Change the hydraulic fluid and filter in the Power Unit after every 500 hours of use.
"
Pool Water Chemistry
It is important for the long-term operation of your Fastlane that your pool water is
"
properly balanced and in accordance with normal, pool industry standards.
As with any swimming pool, your Fastlane Pool requires water chemistry monitoring.
"
The Water Quality System, which includes automated re-circulating, optional heating
and filtration, does most of the work for you. Balancing and maintaining your pool
water is essential to the life and health of your equipment.
Maintain a minimal level of 0.5 ppm free chlorine in your pool at all times as
"
necessary. Adding 1/2 cup of Clorox a day will add about 0.5 ppm of free chlorine
to a Fastlane Pool. How quickly that chlorine is consumed will depend upon the
water temperature, swimmer load and the amount of direct sunlight the pool
receives.
We have provided water test strips that will help you monitor the chlorine and pH
"
requirements of your Fastlane Pool.
If your Fastlane Pool is located outside, we recommend using the granular form
"
of stabilized chlorine (should have an active ingredient of sodium dichlor) instead of
Clorox.
Pre-dissolve all dry chemicals before putting them into the pool. Failure to do so
"
may result in bleaching or damaging your liner.
Always have your pool running when adding chemicals, liquid or dry.
"
Do not leave pool filled with water without proper chemical treatment and pool
"
maintenance.
Do not leave pool set up without being full of water.
"
Daily:
Test for free chlorine after your swim or at least a few times a week.
"
Add chlorine to maintain free chlorine levels between 0.5 and 1.5 ppm.
"
As you become familiar with the chlorine demand for your Fastlane Pool, you
"
will find that you may not have to test chlorine as frequently in order to
maintain a minimum level of 0.5 ppm.
Page 22 of 26
CARING FOR YOUR FASTLANE POOL