Table of Contents
Advertisement
7. SETTING THE MOWER
Properly setting the cutting height is essential for efficient and safe operation. A properly set mower will make
a more uniform cut, distribute clippings more evenly, require minimal tractor work, and follow the contour of
uneven terrain. NOTE: Avoid very low cutting heights, striking the ground with the blades gives the most
damaging shock loads and will cause damage to the mower and drive. Blades contacting the ground may
cause objects to be thrown out from under the mower deck. Always avoid operating the mower at a height
which causes the blades to contact the ground. OPS-U- 0010
7.1 Setting Deck Height
The cut height for the mower is set by adding or
removing spacers on the lift cylinder rods. The
spacers are of different thicknesses so by using
combinations of the spacers provided you can
adjust your height increments by 1/8"
The cutter should always be operated in the highest
position that will produce the desired cutting results.
Operating at increased heights will minimize the
chances of blades contacting the ground and
discharging debris.
1. Place the tractor and cutter on a level surface.
2. Extend or retract lift cylinders until you reach the desired cutting height.
3. Shut down the tractor, place the transmission in park, and set the parking brake before dismounting the
tractor.
4. Remove or add the necessary spacers on the cylinder rod so that the cylinder returns to the preset cutting
height each time the cutter is lowered.
FX-742 07/16
© 2016 Alamo Group Inc.
OPERATION
Operation Section 4-12
Advertisement
Table of Contents
