Table of Contents
Advertisement
Drivelines
-Cross Journals: 4-8 pumps every 50 Hours
-Lubricate until grease purges from underneath all four needle bearing caps.
-Shield Retaining Bearings: 1 pumps every 50 Hours. The shield bearings are greased by a fitting molded into
the shielding bell. Three pumps are
Check that the driveline shielding is not damaged and rotates freely on the driveline.
-Telescoping Tubes: 5-8 pumps every 50 Hours. The grease fitting will become exposed when the wings are
laying flat. Occasionally (monthly) pull the universal joint halves apart and apply grease to all sides of the shaft.
At least once per year (more often in dusty or dirty conditions) the shielding should be removed and the old
grease wiped from the shaft. Do not use an alcohol or acid based solvent to remove the grease. A fresh coat of
grease should be applied to the entire surface of the inner tube.
If the universal joint sliding members are allowed to dry out to the point where two halves
cannot slip freely, damage to the rotary cutter or tractor may occur.
IMPORTANT: Scan this QR Code with your smart phone to link to the ADMA
Driveline Safety Manual for more information on the safe use of a driveline during
normal operation and maintenance. Or type in your internet browser the following
web address: www.algqr.com/dme
Cutter Frame
This rotary cutter uses Greaseless Garmax MLG bushings and nitrided pins in most locations to eliminate
greasing.
Castor Wheel Frame: Every 8 hours. Fill until grease is seen purging from the ends of the seamless
Wheel Hubs: Every 50 hours. Fill until grease is seen purging at the pivot bearing seals.
Wing Lift Turnbuckle: Every 8 hours. Fill until grease is seen purging from ends.
FX-742 07/16
© 2016 Alamo Group Inc.
MAINTENANCE
required.
Ops-0009-MISC
Maintenance Section 5-9
Advertisement
Table of Contents
