Table of Contents
Advertisement
ASSEMBLY
Wiring of Lights
From the light module, plug the 4-pin right signal output plug to the short extension harness. Plug the 3-pin
plug to the red lamp and the 2-pin plug to the amber plug.
From the light module, plug the 4-pin left signal output plug to the long extension harness. Plug the 3-pin plug
to the red lamp and the 2-pin plug to the amber plug.
Plug the main harness to the input end of the light module. Using plastic wire ties, route the harness along the
hydraulic hoses to the front of the rotary cutter. Allow enough slack in the harness for turning.
Test the circuit. The lights should operate in unison with your tractor lights. If the turning lamps are opposite to
the tractor, reverse the output to extension harness connections. If the lights do not work at all, check all
connections are snug.
FX-742 07/16
Assembly Section 3-6
© 2016 Alamo Group Inc.
Advertisement
Table of Contents
