5. If you enabled Check Firmware Version,
the Utility compares the device's
firmware level with that of the upgrade
files. If the device's version is higher
than the upgrade version, a dialog
box below will give you the option to
Continue or Cancel.
6. If you did not enable Check Firmware
Version, the Utility installs the upgrade
files without checking whether they are
of higher level, or not.
7. As the Firmware Upgrade proceeds,
a vstatus message will appear in
the Status Messages panel, and the
progress toward completion is shown on
the Progress bar
8. After the upgrade has completed, a
screen appears to inform you that the
procedure was successful. Click Finish
to close the Firmware Upgrade Utility.
9. After a successful completion, the
GCS1932H/GCS1934H will exit the
Firmware Upgrade Mode and resets
itself.
10. If the GCS1932H/GCS1934H is under
DCC mode installation, then please be
sure to reconnect the cable connected
to the DCC port and set the DCC switch
on the Client KVM switch back to "s"
(Client)(see Six-Display DCC Mode)
Firmware Upgrade Fail
If the Upgrade Succeeded screen does not appear, this means that the upgrade failed to
complete successfully. If this occurs, please follow below steps:
1. Power off the GCS1932H/GCS1934H by removing the power adapter
2. Invoke Firmware Upgrade Mode by holding down the Mode Selection pushbutton
on the front panel (see Mode Selection Pushbutton) and power on the GCS1932H/
GCS1934H . The orange LEDs flash together.
3. Repeat the upgrade procedure from the beginning (see Before Starting Firmware
Upgrade).
25