SunStar SWF/B Series User Manual page 18

12) AUTOMATIC TRIMMING
The automatic trimming function, determined by the design and the machine set-up, enhances work productivity and
quality of the finished product.
13) AUTOMATIC DETECTION OF UPPER AND LOWER THREAD BREAKS
The machine detects when the upper thread breaks or the lower thread is out of the needle and automatically stops
the machine.
14) AUTOMATIC RETURN TO STOP POINT IN UNEXPECTED BLACKOUT
When the power fails unexpectedly, the frame moves back to the exact point where the stitching stopped. This helps
reduce the number of defects.
15) 3.5'' FLOPPY DRIVE (EMBEDDED)
A 3.5'' floppy drive is embedded in the operation panel for you to read or store designs. Both 2DD and 2HD disks
can be used.
16) EDITING
You can delete, change, or insert stitch data and function codes (jump, finish, trimming).
17) INDIVIDUAL HEAD OPERATION
You can work on the specific head with a broken thread.
18) MACHINE STOPPAGE
The screen will indicate why the machine has stopped.
19) RPM
The screen indicates rpm.
20) FRAME SPEED SET-UP
You can adjust the frame speed to high, medium, or low.
21) UNUSED MEMORY
The screen indicates the memory available for use.
22) TAPE CODE COMPATIBILITY
2-binary and 3-binary tape codes can be edited.
23) 10.4 INCH COLOR LCD MONITOR (OPTIONAL)
You can install a 640*480 color LCD monitor onto your operation panel for easier reading of data.
24) CODES FROM OTHER BRANDS
The machine can automatically read designs of various formats stored in the floppy disk.
[ These formats include ]
1. SST
4. FMC, FDR
7. EXP
2. DST, DSB, DSZ
5. ZSK
4-2
3. TAP
6. 10O