Muratec MFX-2500 Operating Instructions Manual page 87

What you see on the
LCD
Not store in Secure box
PIN is not stored
Please call service
Please supply paper
Please wait
Printing
Scanner in use
Too many characters
Too many locations
Too many steps
Sure to register?
What it means/What to do
You tried to store a document for polling in an
F-Code box which is set to be a security box.
Select an F-Code box which is set to be a bulletin
box, then try again.
You selected "Mode1" in the mask feature
PIN
and tried to call an autodialer number in which
no PIN has been entered, or to call using
numeric keypad without . Enter a
PIN
try again.
The printer unit of your fax machine has become
inoperable. Call your authorized Muratec dealer
or Muratec Customer Support.
The paper cassette is out of paper. Add paper to
the cassette.
Your fax machine's printer is either warming up
or busy. Please wait until the fax is finished
printing and then re-try your command or opera-
tion.
The command you're trying to enter requires the
use of the printer, which is already in use. Wait
for the fax to finish printing, then try again.
The command you're trying to enter requires the
use of the scanner, which is already in use. Wait
for the fax to complete the scan, then retry the
desired command.
You attempted to enter too many numbers or
other characters in the current operation.
Press [Cancel] to delete the extra characters,
then try again. You may wish to review the oper-
ation's appropriate instructions.
You tried to enter department code more than
100. Your machine can store up to 100 depart-
ment codes.
You tried to enter too many steps for a macro.
You can enter up to 60 steps into a macro key.
Press [YES] to tell your fax to register these
steps, or press [NO] to cancel the registering.
What you see on the
Unable to reduce
, then
PIN
What it means/What to do
LCD
In enlargement transmission, you cannot select
the reduction ratio.
Trouble Shooting
4.3