Resolution, Grayscale And Contrast; Entering A Pause Character When Dialing - Muratec MFX-2500 Operating Instructions Manual

Getting started

Resolution, grayscale and contrast

Reviewing resolution and grayscale:
• Normal resolution is suitable for most typed documents and simple drawings.
• Fine resolution is ideal for maps, moderately complicated drawings, floorplans or
handwritten documents.
• Superfine resolution (" -
S FINE
extremely complicated drawings or line art.
• Grayscale mode ("
HALFTONE
shades in photos and drawings.
Note: If you send a fax in superfine, certain fax models (especially older, non-
Muratec models) receive it only in fine mode. However, you can send a fax in
grayscale mode to virtually any fax machine currently in use.
To change the resolution setting, press
A glowing
LED
that .
LED
Reviewing contrast:
Setting the contrast allows you to compensate for any excessive lightness or dark-
ness, as the case may be, of document pages you are sending or copying.
Pressing to select the contrast mode:
CONTRAST
– Darkens weak, "washed-out" images.
DARK
= – Provides some darkening of documents.
– Suited to most documents.
NORMAL
= – Provides some lightening of documents.
– Lightens up overly dark documents.
LIGHT
– This mode automatically set the suitable setting
AUTO
Note: You can set the primary mode of the resolution and contrast.
⇒ See Page 3.1.
1.6
" on the control panel) reproduces the detail of
" on the control panel; "Gray" on the
RESOLUTION
indicates the machine is using the setting named by
according to the document density.
Mixing resolution and contrast in a multiple page
When you send the document with more than one page, you can select different
resolutions and contrasts for each page.
Place your document, select resolution and contrast for first page, dial and press
. Then follow one of the following two procedures.
START
When the document is placed in the ADF
Select resolution and contrast before the next page is scanned.
) captures
LCD
When the document is placed on the FBS glass
1
Remove the previous page and place the next page.
2
Select resolution and contrast. Then press
repeatedly.
Entering a pause character when dialling
Some long-distance systems require dialling pauses, and pauses can also be useful
when you're dialling through special telephone exchanges.
When you are dialling or storing the autodialer, and you want to insert a pause
character, press
press [Pause] after you've dialled at least one other character. -/ (the pause char-
acter) will appear on the
Each pause entered lasts for a factory-set two seconds.
For example, if the pause is at the factory setting, pressing 9,
19725552009 dials 9 [2-second pause] 1 9 7 2 5 5 5 2 0 0 9.
Note: Each pause uses two of the characters you're allowed in a number.
Note: To change the dialling pause length, see "Changing the pause length," page
3.6).
START
until the [Pause] is appeared on lower part of the
NEXT
.
LCD
.
, then
LCD
, [Pause],
NEXT