Download Print this page

Freescale Semiconductor TWR-K40D100M Quick Start Manual

Tower system development board platform. low-power mcu with usb and segment lcd

Advertisement

Quick Links

TWR-K40D100M
Quick Start Guide
Low-Power MCU with USB
and Segment LCD
Tower System
Development Board
Platform

Advertisement

loading

Summary of Contents for Freescale Semiconductor TWR-K40D100M

  • Page 1 TWR-K40D100M Quick Start Guide Low-Power MCU with USB and Segment LCD Tower System Development Board Platform...
  • Page 2 Connector MK40DX256VMD10 Secondary Kinetis MCU Connector Figure 1: Front side of TWR-K40D100M board without Tower plug-in (TWRPI) TWR-K40D100M Freescale Tower System Development Board Platform The TWR-K40D100M board is part of the Freescale Tower System, a modular development board platform that enables rapid prototyping and tool re-use through reconfigurable hardware.
  • Page 3 TWRPI-SLCD Board Figure 2: Front side of TWR-K40D100M board with TWRPI-SLCD attached Potentiometer SD Card Socket VBAT (RTC) Battery Holder Figure 3: Back side of TWR-K40D100M board...
  • Page 4 Installation Instructions • MK40DX256VMD10 MCU (100 MHz In this Quick Start Guide, you will learn how Cortex -M4 core, 512 KB flash, to set up the TWR-K40D100M module and ® ® SLCD, USB FS OTG, 144 MAPBGA) run the default demonstration.
  • Page 5 Explore mini-B connector on the TWR-K40D100M module. Allow the PC to automatically Further configure the USB drivers if needed. Explore all of the features and capabilities Tilt the of the preprogrammed demo by reviewing Board the lab document located at freescale.com/TWR-K40D100M.
  • Page 6 Quick Start Guide TWR-K40D100M Jumper Options The following is a list of all jumper options. The default installed jumper settings are shown in shaded boxes. Jumper Option Setting Description Onboard power supply set to 3.3 V V_BRD Voltage Onboard power supply set to 1.8 V...
  • Page 7 freescale.com Jumper Option Setting Description OSJTAG bootloader mode (OSJTAG firmware OSJTAG Bootloader reprogramming) Selection Debugger mode Connect onboard 5 V supply to JTAG port (supports JTAG Board Power powering board from JTAG pod supporting 5 V supply ouput) Connection Disconnect onboard 5 V supply from JTAG port Connect PTD7/CMT_IR0 to IR transmitter (D5) IR Transmitter Connection...
  • Page 8: Warranty

    Freescale, the Freescale logo, the Energy Efficient Solutions logo and Kinetis are trademarks of Freescale Semiconductor, Inc., Reg. U.S. Pat. & Tm. Off. Tower is a trademark of Freescale Semiconductor, Inc. All other product or service names are the property of their respective owners. ARM and Cortex are registered trademarks of ARM Limited (or its subsidiaries) in the EU and/or elsewhere.