Step 5 - Finish Upload - mikroElektronika CLICKER 2 STM32 Manual

A compact starter kit with your favorite microcontroller and two mikrobus sockets

Table of Contents

step 5 – Finish upload

Figure 3-7: Restarting MCU

Click OK button after the uploading process is finished.

Press Reset button on clicker 2 for STM32 board and

wait for 5 seconds. Your program will run automatically.

Figure 3-8: mikroBootloader ready for next job

Page 14

Table of Contents

Need help?

Do you have a question about the CLICKER 2 STM32 and is the answer not in the manual?

Mikroe-1685