Ignition 2bright Pint TW200 IP User Manual page 35

Setting the behaviour on DMX
control failure
1.
Press [MENU] and then [UP] or [DOWN] repeatedly until the display shows 'Settings' .
Confirm with [ENTER].
2.
Press [UP] or [DOWN] repeatedly until the display shows 'DMX Fail' . Confirm with
[ENTER].
3. Use [UP] or [DOWN] to choose between 'Hold Last' , 'Blackout' and 'Manual' , to make the
setting to be used when the DMX controller fails.
The following sub menus are available:
Menu level 3
'Hold Last'
'Blackout'
'Manual'
4.
Press [ENTER] to accept the selection.
Function
The last received signal is held.
The spotlight is turned off.
The device calls up the values set in the 'Stand Alone' menu.
Operating
2bright Pint TW200 IP
35
LED PAR