Chevrolet Cruze Manual page 82

82 Instruments and controls
If the control indicator does not go out
after a few seconds, or if it illuminates
while driving, there is a fault in the
ABS. The brake system remains
operational but without ABS
regulation.
Antilock brake system 3 169.
Upshift
[ illuminates green when upshifting
is recommended for fuel saving
reasons.
Power steering
c illuminates yellow.
Illuminates with power steering
reduced
Power steering is reduced due to
overheating of the system. Control
indicator goes out when the system
has cooled down.
Illuminates with power steering
disabled
Failure in the power steering system.
Consult a workshop.
Illuminates after interruption of
power supply
The steering angle sensor must be
calibrated to make the power steering
system operational.
■ For automatic calibration drive in
straight line at constant slow speed.
■ If the control indicator remains
illuminated, turn the steering wheel
from limit position to limit position
for manual calibration.
The control indicator goes out when
the system is operational again.
Stop-start system 3 161.
Ultrasonic parking assist
r illuminates yellow.
Fault in system
or
Fault due to sensors that are dirty or
covered by ice or snow
or
Interference due to external sources
of ultra sound. Once the source of
interference is removed, the system
will operate normally.
Have the cause of the fault in the
system remedied by a workshop.
Ultrasonic parking sensors 3 173.
Electronic Stability Control
off
n illuminates yellow.
Illuminates when the system is
deactivated.
Electronic Stability Control
and Traction Control
system
b illuminates or flashes yellow.
Illuminates
A fault in the system is present.
Continued driving is possible. Driving
stability, however, may deteriorate
depending on road surface
conditions.