Chevrolet Cruze Manual page 200

200 Vehicle care
3. Remove tail light assembly. Take
care that the cable duct remains in
position.
4. Unscrew two screws by using a
8 mm spanner or socket wrench
and pull out the socket.
5. Position light (1)
Left-hand drive: Rear fog light
(Left-hand side)/ Reverse light
(Right-hand side) (2)
Right-hand drive: Reverse light
(Left-hand side)/ Rear fog light
(Right-hand side) (2)
6. Push bulb into socket slightly,
rotate anti-clockwise, remove and
renew bulb.
7. Insert socket into the tail light
assembly and screw into place.
Install tail light assembly in body
and tighten screws. Refit the inner
panelling with both pins.
8. Switch on ignition, operate and
check the lights.
4-doors, variant 2
1. Open both covers.