Chevrolet Cruze Manual page 162

162 Driving and operating
The engine will be switched off while
the ignition stays on.
An Autostop is indicated by the
needle at the AUTOSTOP position in
the tachometer.
During an Autostop, the heating and
brake performance will be
maintained.
Caution
The steering assist can be
reduced during an Autostop.
Conditions for an Autostop
The stop-start system checks if each
of the following conditions is fulfilled.
■ The stop-start system is not
manually deactivated
■ the bonnet is fully closed
■ the driver's door is closed or the
driver's seat belt is fastened
■ the battery is sufficiently charged
and in good condition
■ the engine is warmed up
■ the engine coolant temperature is
not too high
■ the engine exhaust temperature is
not too high, e.g. after driving with
high engine load
■ the ambient temperature is not too
low
■ the climate control system allows
an Autostop
■ the brake vacuum is sufficient
■ the self-cleaning function of the
diesel particle filter is not active
■ the vehicle has moved since the
last Autostop
Otherwise an Autostop will be
inhibited.
Ambient temperature near to the
freezing point can inhibit an Autostop.
Certain settings of the climate control
system may inhibit an Autostop. See
climate control chapter for more
details.
Immediately after motorway driving
an Autostop may be inhibited.
New vehicle running-in 3 156.
Battery discharge protection
To ensure reliable engine restarts,
several battery discharge protection
features are implemented as part of
the stop-start system.
Power saving measures
During an Autostop, several electrical
features such as auxiliary electric
heater or rear window heating are
disabled or switched into a power
saving mode. The fan speed of the
climate control system is reduced to
save power.