Table of Contents
Advertisement
15. See assembly steps 4 and 5. Tighten the
M10 x 20mm Screws (40) and the M10 Locknut
(33). Then, press the Top Shield (41) into place.
Next, apply a small amount of grease to an M6
Bolt Set (25).
Hold the end of the Right Pedal Arm (12) inside
the bracket on the right Upper Body Leg (5).
Attach the right Upper Body Leg (5) to the Right
Pedal Arm (12) with the M6 Bolt Set (25).
Repeat this step on the other side of the
elliptical.
16. Make sure that all parts are properly
tightened. Extra parts may be included. Place a
mat beneath the elliptical to protect the floor.
Next, plug the Power Adapter (75) into the
receptacle on the frame of the elliptical.
Then, plug the Power Adapter (75) into an
outlet (see HOW TO PLUG IN THE POWER
ADAPTER on page 16).
15
41
16
14
5
25
Grease
25
12
75
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the CADENCE LE and is the answer not in the manual?
Questions and answers
Does it have FTMS bluetooth compatibility? i **** trying to find out if i need to purchase a cadence sensor to connect to holofit.
The manual mentions Bluetooth connectivity for heart rate monitors and tablet connections but does not specify FTMS Bluetooth compatibility. It also does not mention the need for a separate cadence sensor to connect to Holofit. Therefore, the answer to both parts of the question cannot be determined from the provided information.
This answer is automatically generated