Link View - 32 Mbit - IBA ibaFOB-D Manual

ibaFOB-D
8.1.3 Link view – 32 Mbit
Figure 14: Link information at 32 Mbit
When you click on a link in the tree view then you get information about this link. The
information on the left describes the fiber optic (FO) communication. The displayed in-
formation will depend on the current protocol on the FO link.
"Link" area
 Communication status
OK when the FO communication is working well. This means that the telegrams
that are being received correspond with the mode that is configured on the link. The
link mode is determined by the module that is attached to the link, e.g. if an
ibaPADU-8 module is configured then the link will be set in 3Mbit mode. If an
ibaPADU-8-ICP module is configured then the link will be set in 5Mbit mode.
 Detected link protocol
This is the link protocol that the board detects. This can be 2Mbit, 3Mbit, 5Mbit,
32Mbit, 32Mbit Flex or "?" (No device connected).
 Selected link protocol
This is the link protocol set for this link. It is determined by the attached module.
 Telegram counter
Counter of correctly received telegrams
 Error counter
Counter of received telegrams that have errors (e.g. incorrect checksum)
If this counter changes, the FO communication does not work correctly.
 Time between telegrams
The time interval between the last 2 correctly received telegrams.
Manual
Issue 1.11 29