Dismounting; Connecting An Ibafob-4O-D Module - IBA ibaFOB-D Manual

6.3

Dismounting

1. Shut down the PC.
2. Switch off the power supply of the PC.
3. Unplug the mains power line.
4. Open the PC so you can reach the PCI(e) slots.
5. Unplug external connections
6. Release the fixing screw.
7. Unplug the board carefully out of the slot. Store the board in an appropriate container.
8. Close the PC.
9. Plug in the power line.
10. Switch on the power supply of the PC.
11. Start the PC.
6.4

Connecting an ibaFOB-4o-D module

If you connect an ibaFOB-4o-D extension module to the board you can either mirror the
incoming data or use output features of iba software applications ibaPDA or ibaLogic.
In mirror mode the incoming data stream is copied without significant delay to the output
channels.
It is possible to use both modes at the same time by using 2 ibaFOB-4o-D modules.
Figure 5:
22
ibaFOB-4o-D module (long and short)
Manual
Issue 1.11
ibaFOB-D