Status Display Of Fiber Optic Inputs; 7-Segment Display - IBA ibaFOB-D Manual

ibaFOB-D
5.7

Status display of fiber optic inputs

LED
Green
(Run)
Yellow
(Link
Slow)
White
(Link Fast)
Red
(Error)
5.8

7-segment display

The 7-segment display shows the following information:
 Horizontal segment only:
 Numbers 0 to 7:
 The decimal point in the display indicates whether the board is configured to be:
 An internal interrupt master (dot is on) or
 An external interrupt master (dot is blinking) or
 An interrupt slave (dot is off)
Status Description
Flashing Power is on and the channel is functioning properly
OFF Controller stopped (hardware failure)
ON Receiving 2Mbit, 3Mbit or 5Mbit telegrams on this channel, link cor-
rectly configured
Flashing Receiving 2Mbit, 3Mbit or 5Mbit telegrams on this channel, but link
configured for another protocol
32Mbit Flex mode: TCP/UDP telegram detected via FO (flashing unsteady)
OFF No 2Mbit, 3Mbit or 5Mbit telegram detected
ON Receiving 32Mbit or 32Mbit Flex telegrams on this channel, link cor-
rectly configured
Flashing
Receiving 32Mbit or 32Mbit Flex telegrams on this channel, but link
configured for another protocol
OFF No 32Mbit or 32Mbit Flex telegram detected
ON Watchdog alarm
Flashing Running the "Golden FPGA Flash Rescue mode"
OFF Normal state
Board not initialized
Board ID after board was initialized
Manual
Issue 1.11 19