Ignition Switch Control With The 7-Seg Display Panel - Sensata Dimensions 24NP36 Owner's Manual

Ignition Switch Control with the 7-Seg Display Panel

The 7-Seg Display Panel can be wired to the vehicle ignition circuitry to control operation of the inverter. When the
ignition is turned on, the inverter has a built-in delay which will turn it on after 10 seconds. For the inverter to work
in this way, the 7-Seg Display Panel must be programmed for this type of operation. This is done by having either
AC or DC power applied to the inverter and then following these instructions:
Ignition Programming
1. Press and hold "Menu" & "Display/Select" for 5 seconds. The green "Fault" LED comes on.
2. Press "Menu" once. Display scrolls:
ctl tAb OFF
3. Press "Display/Select." Display stops at:
OFF
4. Press "Display/Select" and the display changes to:
IGn
The "On/STBY" LED will also blink amber (if unit is connected to AC power).
5. Press the "Batt Test" key. Disconnect power to the system and complete wiring.
Complete Wiring
1. Using an insulated female faston and 18 AWG wire, connect to the faston tab on the backside of the 7-Seg
Display Panel.
2. Wire the other end through a 5-amp inline fuse to the ignition circuitry of the vehicle.
NOTE: Repeat steps 1–5 to turn this feature off again.
Page 32
Figure 12 Seven-Segment Display Panel
24NP Manual