Related Manuals for Sensata 24TX60
Summary of Contents for Sensata 24TX60
- Page 1 DC to AC POWER INVERTERS Quasi-Sine Wave 3-Phase Output MODEL: 24TX60 OWNER’S INSTRUCTIONS Form: 122189 © 2012 Sensata Technologies...
-
Page 2: Table Of Contents
1. Safety Instructions ……………. 2. Specifications …………………. 3. Technical Description …. …….. 4. Inverter Description…………… 5. Status Panel Description……... 6. Installation ……………..... 9-11 7. Operation & Troubleshooting... 8. Limited Warranty ……………… 9. Notes …………………………… Form: 122189 © 2012 Sensata Technologies... -
Page 3: Safety Instructions
Remove all rings, watches, jewelry or other conductive items before working near the batteries. Inspect the batteries once a year for cracks, leaks or swelling. Dispose of the batteries according to local regulations. Do not incinerate batteries; risk of explosion exists. Form: 122189 © 2012 Sensata Technologies... -
Page 4: Specifications
Usage: Any 220VAC, 60 Hz, single or 3 phase product and/or 120VAC, 60Hz, single phase equipment within the inverter’s power rating that does not require a pure sine waveform. Warranty: Full 2 year parts and factory labor Specifications are subject to change without notice. Form: 122189 © 2012 Sensata Technologies... -
Page 5: Technical Description
3.4.1 Inverter Cable assembly kit: The inverter has a cable kit that includes several parts that are required to be installed to maintain the chassis seal. Please see the picture below for piece parts. The kit also includes an orange wire (not pictured). Form: 122189 © 2012 Sensata Technologies... - Page 6 16 in lbs in a specific sequence. ! NOTE: The inverter serial number and date code are inside the DC box FIGURE 1: DC COVER PLATE (Tightening sequence and torque specification.) Form: 122189 © 2012 Sensata Technologies...
-
Page 7: Inverter Description
4 Inverter Physical Descriptions: Inverter Module FIGURE 2: Chassis physical description and installations dimensions. FIGURE 3: DC Box (! See torquing requirements for cover plate; round seal goes on outside of box DC cable Heyco strain reliefs) Form: 122189 © 2012 Sensata Technologies... -
Page 8: Status Panel Description
5 Status Panel Descriptions: LED Remote Status Panel (Sensata Part Number 245035) FIGURE 4: LED Status Panel Inverter power: Green LED that indicates the inverter is operating from in “Inverter Mode”. Low battery: Red LED that indicates the inverter is in a “Low Battery” voltage condition. -
Page 9: Installation
CAUTION: Be sure the inverter is turned "OFF" during installation. National Electric Code, provincial or other codes in effect at the time of installation, regardless of suggestions in this manual. All wires should be copper conductors. Form: 122189 © 2012 Sensata Technologies... - Page 10 6.4.7 CAUTION: Connecting the inverter to the wrong polarity of the battery will cause damage that is not covered under warranty. 6.4.8 3-phase DC Input Lug Torque; UL 486E states 30 ft/lbs. for brass, therefore, the recommended torque is or 30 ft. lbs. (360 in. lbs.). Form: 122189 © 2012 Sensata Technologies...
- Page 11 AC neutral “N”; as L1 and N, or L2 and N, or L3 and N. 6.6.7 Remote AC outlets should be mounted at a convenient location in a listed outlet box with approved strain relief, if used. Form: 122189 © 2012 Sensata Technologies...
-
Page 12: Operation & Troubleshooting
High ambient temperatures combined with poor has shut off due to high internal ventilation may also contribute to the shut down. temperature. unit will automatically turn back on when it has cooled to 40°C (104°F). Form: 122189 © 2012 Sensata Technologies... -
Page 13: Limited Warranty
Sensata and the manufacturer’s written instructions. Sensata’s sole liability and the Purchaser’s sole remedy for a failure of goods under this limited warranty and for any and all claims arising out of the purchase and use of the goods shall be limited to the repair or replacement of the goods that do not conform to this warranty. -
Page 14: Notes
NOTES Form: 122189 © 2012 Sensata Technologies... - Page 15 Important Notice: Sensata Technologies (Sensata) reserves the right to make changes to or discontinue any product or service identified in this publication without notice. Sensata advises its customers to obtain the latest version of the relevant information to verify, before placing any orders, that the information being relied upon is current.