Bosch CL300 Manual page 41

Flexible Automation
Specifications
Ordering Information
2.2.3 Protective Ground Connection
Input Voltage
Output Voltage
Peak−to−average Ripple Factor
Max. Output Current
Input Current at Nominal Load
Connecting Terminals (mm@)
Protection Class
Dimensions H x W x D
24 V DC 6 A
10 A
20 A
40 A
With the use of expansion modules, the following points should be observed to en
sure good protective ground connection:
The basic unit and all expansion units should be connected to the protective
D
ground wire. The connecting cross−section should be as large as possible.
The flat−cable connector on the front panel of the destination expansion unit
D
should be connected to the protective ground wire when two AG/Z units are
interconnected.
When an AG/P module is connected to an AG/Z module, the flat−cable con
D
nector on the AG/Z front panel should be connected to the protective ground
wire.
In case of interference problems, it is recommended to also connect the flat−
D
cable connector on the AG/P front panel to the protective ground wire.
Configuration
380 V/3−phase/50 Hz
24 V DC to DIN 19240
5 %
6 A, 10 A, 20 A, 40 A
0.3 A, 0.45 A, 0.83 A, 1.7 A
1.5, 1.5, 2.5, 2,5
IP00
165 mm x 300 mm x 100 mm,
185 mm x 340 mm x 140 mm,
240 mm x 420 mm x 140 mm
Order No.
913 485
913 486
913 487
913 488
2−29