Input Address Range Ie 24− 16 Inputs - Bosch CL300 Manual

Flexible Automation
The IE module is to be operated in the extended inputs/outputs
D
EI/EO.
On the module the card address must be set to 0" because the
D
inputs EI1.0, EI1.1, and EI1.2 are defined as interrupt signals. The
remaining five I inputs are inhibited.
Input Address Range
EI1.7
X X X
Byte with
higher priority
I−Inputs
Fig. 4−19 Input address range IE 24− 16 inputs
After the program has jumped to the appropriate interrupt organ
D
izational module OM2−OM4, all other interrupts are inhibited and
can be reactivated using the PLC command IF".
The PLC commands IR, IS, and IF are used to reset, inhibit or en
D
able the interrupt inputs.
The arithmetic registers A, B, C of the CL300 controller must be
D
saved by the user, if necessary, after the jump to the interrupt or
ganizational module.
System Modules
EI0.0
Byte with
lower priority
High−speed Inputs
4−39