Default Settings; Special Mta Settings; Phoenixbios Settings Btv20.3, Processor Specification -55 - Bosch Rexroth MTA 200 Planning Manual

Project Planning Manual | Rexroth MTA 200

Default Settings

Special MTA Settings

6.3.5

PhoenixBIOS Settings BTV20.3, Processor Specification -55

Part of the Setup Position on the screen Function
screen
Menu bar Top
Navigation bar Bottom
Specific help Right
Menu contents Left
"General Help" Front and center
Fig.6-5: Division of the PhoenixBIOS Setup menu
Pressing the <F9> key loads the "Default Setup Configuration".
The default values for the BTV 20.3 are listed in the following tables.
It is not necessary to make any changes to the BIOS settings in the BTV 20.4A
for the MTA 200 control system.
As the NC CPU is equal to the PC CPU only in its appearance, it must be
ensured that the PC CPU is not used as NC CPU and vice versa.
Otherwise, the different BIOS settings of NC CPU and PCU CPU would prevent
the BTV 20.4A from booting!
The BTV 20.4A with processor configuration 45 mandatorily re‐
quires a MTA software version 23VRS or higher. The BTV 20.4A
cannot be operated with older versions!
Main
System Time:
System Date:
System Memory:
Extended Memory:
Legacy Diskette A:
Primary Master
Primary Slave
Secondary Master
Secondary Slave
Keyboard Features
Boot Options
Fig.6-6: Main menu
Electric Drives | Bosch Rexroth AG
and Controls
PC CPU Configuration -55
Display and selection of all "Top-Lev‐
el" menus
Display of the Setup navigation key
functions
Help for the currently selected menu
item
Display of the current menu
Display of the Help
Current time
Current date
640 KB
1038336 KB
1.44/1.25 MB 3½"
Autodetected drive / submenu
Autodetected drive / submenu
Autodetected drive / submenu
Autodetected drive / submenu
Submenu
Submenu
77/135