Default Settings; Special Mta Settings; Phoenixbios Settings For The Btv 20.4 - Bosch Rexroth MTA 200 Planning Manual

Project Planning Manual | Rexroth MTA 200

Default Settings

Special MTA Settings

5.3.5

PhoenixBIOS Settings for the BTV 20.4

Part of the Setup Position on the screen Function
screen
Menu bar Top
Navigation bar Bottom
Specific help Right
Menu contents Left
"General Help" Front and center
Fig.5-5: Division of the PhoenixBIOS Setup menu
Pressing the <F9> key loads the "Default Setup Configuration". However, these
are not the "Default" values for the BTV 20.4!
The default values for the BTV 20.4 are listed in the following tables.
It is not necessary to make any changes to the BIOS settings in the BTV 20.4A
for the MTA 200 control system.
As the NC CPU is equal to the PC CPU only in its appearance, it must be
ensured that the PC CPU is not used as NC CPU and vice versa.
Otherwise, the different BIOS settings of NC CPU and PCU CPU would prevent
the BTV 20.4A from booting!
The BTV 20.4A with processor configuration 45 mandatorily re‐
quires a MTA software version 23VRS or higher. The BTV 20.4A
cannot be operated with older versions!
Main
System Time
System Date
Legacy Diskette A
Legacy Diskette B
Primary Master
Primary Slave
Secondary Master
Secondary Slave
Memory Shadow
Memory Cache
System Memory
Extended Memory
Fig.5-6: Main menu
Electric Drives | Bosch Rexroth AG
and Controls
PC CPU Configuration -45
Display and selection of all "Top-Lev‐
el" menus
Display of the Setup navigation key
functions
Help for the currently selected menu
item
Display of the current menu
Display of the Help
Current time
Current date
1.44/1.25 MB 3½"
disabled
Autodetected drive / submenu
Autodetected drive / submenu
Autodetected drive / submenu
Autodetected drive / submenu
Submenu
Submenu
Display of the system memory
Display of the Extended Memory
67/135