Replacing The Slide-In Strips; General Information - Bosch Rexroth MTA 200 Planning Manual

Project Planning Manual | Rexroth MTA 200
4.2.6

Replacing the Slide-in Strips

General Information

PLC function key Address key
S6 %I*.0.5
S7 %I*.0.6
S8 %I*.0.7
S9 %I*.1.0
S10 %I*.1.1
S11 %I*.1.2
S12 %I*.1.3
S13 %I*.1.4
S14 %I*.1.5
Key switch left side (op‐ %I*.1.6
erator)
Key switch right side %I*.1.7
(Prog)
Fig.4-10: Addressing of the PLC function keys
Two vacant logical addresses are to be assigned for inputs and outputs within
the PLC configuration.
The 14 PLC function keys on the front of the BTV 20 can be labeled by using
a slide-in strip . The key row above the PLC function keys (OP2...OP9) is also
freely configurable using slide-in strips.
These strips, which are already inserted when the device is delivered, can be
freely replaced. Preprinted strips as well as a floppy-disk with templates are
also included in the scope of delivery so that you can create your own key
labels. How to replace the slide-in strips is decribed below.
Electric Drives | Bosch Rexroth AG
and Controls
Machine Operator Terminal BTV 20.4A
Address LEDs
%Q*.0.5
%Q*.0.6
%Q*.0.7
%Q*.1.0
%Q*.1.1
%Q*.1.2
%Q*.1.3
%Q*.1.4
%Q*.1.5
%Q*.1.6
%Q*.1.7
31/135