32/135
Bosch Rexroth AG | Electric Drives
Machine Operator Terminal BTV 20.4A
How to Replace Slide-in Strips
and Controls
Fig.4-11:
Position of the openings for slide-in strips
1.
The delivered or self-made strips are to be cut out along the lines .
2.
Chamfer the corners at the right end of each strips in order to simplify the
insertion.
3.
Insert the strip carefully.
●
To do this, hold the strip at an acute angle to the front plate and thread
it into the housing opening (see
on page
33, part A).
Note: The slide-in strip is to be inserted into the pocket of the glued
front-film (see
Rexroth MTA 200 | Project Planning Manual
fig. 4-12 "Replacing slide-in strips"
fig. 4-12 "Replacing slide-in strips" on page
33). If