Adaptec RAID 2130SLP User Manual page 124

Error Message Text
LogOut
MaybeReadCache
MaybeWriteCache
MergeOwnNS
Rebuild
RemoveAHS
RemoveFromDiskSet
RemoveHSP
RemoveSHS
ReplaceDHS
RollbackSnapshot
ScanDrives
SetArrayOnline
SetChannelInitiatorId
SetContDiskCachePolicy
SetHostId
SetITNexusLossTime
SetMergeGroup
SetPartnerId
SetSpareSet
SetToAHotSpare
SetToDefunct
SetToEmpty
SetToHotSpare
SetToOnline
SetToSHotSpare
SetWce
SyncArray
SyncLogDrive
Explanation
The user could not be logged out
Could not set read cache mode to 'enabled when protected by battery'
Could not set write cache mode to 'enabled when protected by battery'
Could not copy the configuration from the non-shared logical drives
Could not set the drive to the specified rebuild state
Could not delete the dedicated hot spare drive
Could not remove drives from the specified diskset
Could not delete the specified hot spare drive
Could not delete the specified standby hot-spare drive
Could not replace the specified failed drive
Could not rollback the specified snapshot
Could not perform the bus rescan
Could not send the Array Optimal command to the specified controller
Could not set the specified SCSI initiator ID
Could not change the specified global drive cache policy
Could not set the specified controller name
Could not change I_T nexus loss time
Could not set the specified merge-group number
Could not set the specified partner controller name
Could not change the specified spare set attribute
Could not create a dedicated hot spare drive
Could not set the specified drive to failed
Could not remove the specified failed drive
Could not create a hot-spare drive
Could not set the specified failed drive to optimal
Could not create a standby hot-spare drive
Could not change the write-cache mode
Could not start the array verify
Could not start the logical drive verify
Chapter 12: Solving Problems
●
124