Directechs DB3 Installation Manual page 6

All-in-one door lock and override module for chevrolet cruze 2021
Hide thumbs Also See for DB3:
Table of Contents

Advertisement

Wiring diagram
with
T-Harness (THGMD1 Rev.1 & 3)
Refer to "Pre-installation and application warnings" for important information, such as the description of each special note referenced in the diagram (
Ignition Connector
(black connector at ignition switch)
To
Ignition Barrel
Vehicle
To
Ignition
To
Immobilizer Control Module
(violet connector
under ignition switch)
Away from
Immobilizer Control Module
(vehicle side)
(-) Parking Lights: Pin 3, 5 or 7
Headlight Switch
(black 12-pin connector)
6
403.GM10 4.16 2011 Chevrolet Cruze
© 2019-03-01 Directed. All rights reserved.
NOT USED
Type 2
Type 1
Refer to the
Vehicle
connections
section for the
1 2
3 4
5
6
corresponding
7
8
9
10
11
12
connector, pin
and wire color
of your vehicle.
(-) Driver Door Trigger
Refer to the Vehicle connections section.
SW CAN: Pin 1
HS CAN High: Tan/Black
SW CAN: Lt. Green
HS CAN Low: Tan
THGMD1 Rev.1 & 3 (Optional T-Harness)
(-) Parking Lights Output: Black/White
(-) RAP Off Output: Green/Black
Hood: White/Black
Hood Pin
Note: The hood pin is
only required on
vehicles that are not
equipped with a
factory hood pin.
OBDII Diagnostic
(connector side view)
HS CAN High: Pin 6
1
8
9
16
HS CAN Low: Pin 14
Remote Start
Safety Override
Switch
).
The Remote Start Safety
Override Switch MUST
be in the ON position.

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DB3 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents

Save PDF