Table of Contents
Advertisement
5-10. Setting Whether to Display / Hide the Grayscale
Warning
You can specify whether to display the Grayscale Display Error message to indicate that a 6-bit
(64-grayscale) signal has been detected when the DisplayPort signal is input at the recommended
resolution. If the error message appears, please turn off the main power, and then turn it on again.
Attention
• Always use with this set to "ON" (the default setting is "ON").
• Set this to "OFF" only when using 6bit (64 grayscale) display.
Procedure
1. Select
to turn off the monitor.
2. While touching the leftmost switch (
monitor.
3. Select "Grayscale Warning" in "Administrator Settings", then select
4. Select "On" or "Off", then select
5. Select "Apply", and then select
5-11. Acquiring Life Estimation Data
You can acquire data required to estimate the monitor's lifespan. The life estimation result based on the
acquired data can be confirmed using RadiCS / RadiCS LE.
Note
• Data is collected every 100 hours.
• If you selected "Power Save" and 100 hours have elapsed, the data collection process runs when the monitor
enters the power saving mode or the power is turned off.
• If "Routine" or "Power Save" is selected, the Integrated Front Sensor starts measurement at the time of data
collection. If "Off" is selected, measurement using the Integrated Front Sensor is not performed at the time of data
collection.
• The collected data is saved at the following timings:
- 500, 1000, 2000, 4000, 7000, 10000, 15000, 20000, 25000, and 30000 hours.
Procedure
1. Select "RadiCS SelfQC" from the Setting menu, then select
2. Select "LEA" for "RadiCS SelfQC", then select
3. Select "Meas. Frequency".
4. Select "Power Save", "Routine", or "Off", then select
), touch
for more than two seconds to turn on the
.
.
.
.
Chapter 5 Configuring Monitor Settings
.
.
23
Advertisement
Table of Contents
