Table of Contents
Advertisement
5-8. Locking Operation Switches
Adjusted or set states can be made unchangeable.
Procedure
1. Touch
to turn off the monitor.
2. While touching the leftmost switch (
3. Select "Key Lock" in "Administrator Settings", then select
4. Select "Off", "Menu", or "All" using
Setup item
Off
Menu
All
5. Select "Apply", and then select
Note
• After calibration is performed using RadiCS / RadiCS LE, "Menu" is selected.
5-9. Selecting the Input Signal for DDC Communication
Specify the input signal to be used for DDC communication. Using DDC communication allows you to
use RadiCS / RadiCS LE without having to use the USB cable. (DDC communication differs from DDC /
CI communication.)
Attention
• In view of the accuracy and speed of communication, USB connection is recommended for RadiCS / RadiCS LE.
Procedure
1. Touch
to turn off the monitor.
2. While touching the leftmost switch (
3. Select "DDC" in "Administrator Settings", then select
4. Select "Off", "DVI", or "DisplayPort 1" using
5. Select "Apply", and then select
5-10. Setting Whether to Display / Hide the Grayscale Warning
You can specify whether to display the Grayscale Display Error message to indicate that a 6-bit
(64-grayscale) signal has been detected when the DisplayPort signal is input at the recommended
resolution. If the error message appears, please turn off the main power, and then turn it on again.
Attention
• Always use with this set to "ON" (the default setting is "ON").
• Set this to "OFF" only when using 6bit (64 grayscale) display.
Procedure
1. Select
to turn off the monitor.
2. While touching the leftmost switch (
monitor.
3. Select "Grayscale Warning" in "Administrator Settings", then select
4. Select "On" or "Off" using
5. Select "Apply", and then select
28
Chapter 5 Configuring Monitor Settings
), touch
or
Lockable switches
None (All switches are enabled.)
Adjust or set using the Setting menu.
All switches except
.
), touch
.
), touch
or
, then select
.
for more than two seconds to turn on the monitor.
.
, then select
.
for more than two seconds to turn on the monitor.
.
or
, then select
for more than two seconds to turn on the
.
.
.
Advertisement
Table of Contents
