Setting Whether To Display / Hide The Grayscale Warning; Enabling Or Disabling Sub Pixel Drive - Eizo RadiForce GX560 Installation Manual

5-12. Setting Whether to Display / Hide the Grayscale Warning

You can specify whether to display the Grayscale Display Error message to indicate that a 6-bit
(64-grayscale) signal has been detected when the DisplayPort signal is input at the recommended
resolution. If the error message appears, please turn off the main power, and then turn it on again.
Attention
• Always use with this set to "ON" (the default setting is "ON").
• Set this to "OFF" only when using 6bit (64 grayscale) display.
Procedure
1. Select to turn off the monitor.
2. While touching the leftmost switch (
monitor.
3. Select "Grayscale Warning" in "Administrator Settings", then select
4. Select "On" or "Off", then select
5. Select "Apply", and then select

5-13. Enabling or Disabling Sub Pixel Drive

The Sub Pixel Drive can be enabled / disabled.
Attention
• If "Sub Pixel Drive" is set to "On", the screen is not displayed properly. Leave the setting "Off" as it is.
• To display in 15 megapixel (15 MsP), software that supports 15 MsP is required.
• When in portrait orientation, sub-pixels are arranged horizontally.
• When "Sub Pixel Drive" is "On", "Sharpness Recovery" is disabled even if it is set to "On".
Procedure
1. Touch to turn off the power to the monitor.
2. While holding down the switch at the far left ( ), touch
power to the monitor.
3. Select "Signal Format" from "Administrator Settings", and select
4. Select "Display Port1", "Display Port2", or "DVI", and select
5. Select "Sub Pixel Drive (Hor.)", and then select
6. Select "On" or "Off", and select
7. Select "Apply", and select
22
Chapter 5 Configuring Monitor Settings
), touch for more than two seconds to turn on the
.
.
.
.
.
.
for at least two seconds to turn on the
.
.