Table of Contents
Advertisement
5-3. Switching the Display Size
You can set the size when displaying images at other than the recommended resolution.
Example:
Full Screen
Procedure
1. Select "Signal" from the Setting menu, then select
2. Select "Picture Expansion", then
3. Select "Full Screen", "Aspect Ratio", or "Dot by Dot", and select
Setting
Full Screen
Aspect Ratio
Dot by Dot
5-4. Setting the DisplayPort Version
You can set the DisplayPort version.
Attention
• When connecting the signal to other monitors using a daisy-chain connection, set to "Version 1.2".
• When a PC is connected via the DisplayPort connector, the DisplayPort version may differ depending on the PC,
and consequently the screen may not appear. In this case, try changing the following settings.
Procedure
1. Select
to turn off the monitor.
2. While touching the leftmost switch (
monitor.
3. Select "DisplayPort" in "Administrator Settings", then select
4. Select "Version 1.1 10bit", "Version 1.1 8bit", or "Version 1.2", then select
5. Select "Apply", and then select
20
Chapter 5 Configuring Monitor Settings
.
Enlarges the image to full-screen size. However, if the height-to-width ratio differs between
the screen and image, the image may be distorted.
Enlarges the image while its height-to-width ratio is maintained. However, if the heightto-
width ratio differs between the screen and image, areas that display nothing may appear
along the horizontal or vertical edges of the screen.
Displays the image at a size according to its resolution.
.
Aspect Ratio
.
Function
), touch
for more than two seconds to turn on the
.
Dot by Dot
.
.
Advertisement
Table of Contents
