6.8 Stator
6.8.1 To disassemble the stator
1. Remove the carbon brushes. Refer to
carbon brushes on page 15 .
2. Remove the carbon brush holders.
3. Remove the 5 screws that hold the rear handle.
1332 - 001 - 04.03.2021
4. Remove the 8 screws that hold the rear handle.
To replace the
5. Make a note of how the motor connection wires from
the terminal of the electronic module are connected.
6. Disconnect the motor connection wires from the
terminal of the electronic module. Remove the rear
handle.
Repair and servicing - 27