Husqvarna DM 200 Workshop Manual page 13

CAUTION: Make sure that the O-ring is not
damaged.
2. Put the motor housing on the middle cover. Align the
screw holes in the gear housing with the holes in the
motor housing. Put the 4 screws in the screw holes.
Make sure that the rotor bearing is attached to the
bearing seat. Tighten the 4 screws.
3. Install the carbon brushes in the holders. Install the
brush connection wires with the 2 screws and the 2
washers.
1332 - 001 - 04.03.2021
4. Install the carbon brush covers with the 2 screws.
5. Install the front handle.
Repair and servicing - 13