Table of Contents
Advertisement
3. Put the pinion shaft into the pinion shaft holder as
the illustration shows.
a) Do a check of the friction clutch with a torque
wrench. Turn the torque wrench clockwise 1-2
times and read the value at the same time. The
specified tightening torque is 10-11 Nm.
b) If the torque is too low, tighten the hex nut
slightly with a wrench. Do a check of the friction
clutch with the torque wrench again. Do the
procedure until you read the correct value.
c) If the torque is too high, loosen the hex nut.
Tighten the hex nut slightly and do a check with
the torque wrench again. Do the procedure until
you read the correct value.
Note: When the friction clutch rotates, it becomes
warm. It increases the torque. Let the friction clutch
become cool before you read the torque again.
6.7 Rotor
6.7.1 To disassemble the rotor
•
Pull off the rotor bearings with the bearing puller
Servicing tools on page 6 .
tool. Refer to
26 - Repair and servicing
6.7.2 To assemble the rotor
1. Put the first ball bearing in the first bearing press
Servicing tools on page 6 . Put the rotor
tool. Refer to
shaft into the first ball bearing. Put the second ball
bearing onto the rotor shaft. Attach the the second
bearing press tool to a mandrel press. Push the ball
bearings onto the rotor shaft with the mandrel press.
2. Install the gear oil seal. Refer to
oil seal on page 14 .
3. Put the middle cover on 2 spacers. Put the rotor into
the bearing seat in the middle cover. Use the second
bearing press tool to push the rotor into the bearing
seat in the middle cover.
To replace the gear
1332 - 001 - 04.03.2021
Advertisement
Table of Contents
