6.1 To clean and examine the product parts
•
Clean and examine all parts fully. You find more
instructions in the chapter for each part if special
tools or procedures are necessary.
•
Replace damaged or defective parts.
•
Always use original spare parts.
6.2 To disassemble the product
1. Remove the front handle.
2. Attach the machine holder tool to a vise. Refer to
Servicing tools on page 6 . Put the product in a
vertical position with the drill spindle in the machine
holder tool.
10 - Repair and servicing
6 Repair and servicing
3. Remove the 2 screws that hold the carbon brush
4. Remove the 2 screws and the 2 washers for the
covers. Remove the carbon brush covers.
connection wires of the carbon brushes. Pull the
carbon brushes out from the holders.
1332 - 001 - 04.03.2021