Table of Contents
Advertisement
7. Push the drill spindle into the gear housing with the
mandrel press.
Note: Push the parts together by hand before you
put the assembly in the mandrel press.
8. Install the 2 snap rings with circlip pliers.
20 - Repair and servicing
6.6.6 To replace the shaft seals for the drill spindle
1. Remove the snap ring (A) with circlip pliers.
2. Push the shaft seals (A), the washers (B) and the O-
rings (C) out of the gear housing with an offset
screwdriver. Tap the offset screwdriver carefully with
a soft head mallet if it is necessary.
CAUTION: Make sure that the metal surface
does not become damaged. Make sure that
the O-rings are not damaged.
A
C
B
A
B
C
1332 - 001 - 04.03.2021
A
Advertisement
Table of Contents
