Original.operating.instructions ● ● Quick.start.instructions.SIEGENIA.Comfort.app. – ● The quick start instructions for the SIEGENIA Comfort app are located behind the front panel (To open the front panel, see page 17). Equipment AEROMAT VT WRG 1000 AEROMAT VT WRG 1000 name smart Operation.via.membrane.key...
Original operating instructions AERO AEROMAT VT WRG 1000 9.3 Ventilation in automatic mode 9.4 Frost protection control (units with exhaust air sensor) • The.supply.air.blower.is.switched.off.automatically. • The.blower.levels.0,.1.and.2.are.controlled.in. as.soon.as.the.outside.temperature.drops.below. automatic.mode..The.required.blower.level.is. ‒15.°C..The.exhaust.air.blower.continues.to.run. activated.by.means.of.the.critical.value. • As.soon.as.the.outside.temperature.increases.above. • The.blowers.are.not.switched.off,.but.continue.to. -15.°C.again,.the.device.switches.to.the.last.level.to. run at a minimum level. be used.
Original operating instructions AERO AEROMAT VT WRG 1000 12 Operation 12.1 Ventilation without blowers 12.3 Adjustment of the blower level using the membrane key • By.pressing.the.membrane.key.several.times,.you. can.activate.the.required.blower.levels.(relaying). • After.a.power.failure,.the.unit.switches.to.the.last. level to be used. Switching sequence (units without exhaust air sensors) Blower.level.0 Blower.level.1 Blower.level.2...
Original operating instructions AERO AEROMAT VT WRG 1000 12.4 Adjustment of the blower level using the 3-stage rotary switch (units without exhaust air sensors) external switch Blower.level.0 Blower.level.1 • You.can.activate.the.required.blower.levels.directly. by.pressing.the.external.switch.(without.relaying). • After.a.power.failure,.the.unit.switches.to.the.last. level to be used. • If.the.membrane.key.is.pressed.when.an.external. switch.is.installed,.the.next.blower.level.will.be. Blower.level.2 Power level activated..Pressing.the.external.switch.again.takes.
Need help?
Do you have a question about the AERO AEROMAT VT WRG 1000 and is the answer not in the manual?
Questions and answers