Tool Connector; Ethernet Cable Connector - Pro-face GP-2400 Series User Manual

Chapter 3 - Installation and Wiring
3.3

Tool Connector

The GP's Data Transfer Cable can be attached to the GP unit's Tool Connector.
To prevent an electric shock, unplug the GP unit's power
cord from the main power supply prior to attaching or de-
taching any connector(s) to or from the GP.
GP-2500 Series, GP-2600 Series
3.4

Ethernet Cable Connector

Use the following drawing to locate your GP unit's Ethernet connector. The GP
Ethernet interface is IEEE802.3 compliant, and transmits data at 10Mbps.
GP-2500 Series, GP-2600 Series
• It is strongly recommended that your Ethernet network is installed by a trained
engineer.
• You may not be able to use the 1:1 connection by a cross cable depending on PCs or
network cards. Be sure to connect those with a hub.
3-10
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
WARNING
Bottom Face
Tool Connector
Bottom Face
Ethernet Interface
(RJ-45 Connector)
Rear Face
GP-2400 Series
Side Face
GP-2400 Series
GP-2400/2500/2600 Series User Manual