Installation - Pro-face PS-A Series Installation Manual

USB Interfaces (USB)
These interfaces are used to connect USB equipment. (Ver.1.1 compatible)
PCMCIA Interfaces (PCMCIA)
These interfaces are used to connect PCMCIA Type I, Type II cards.
Speaker Output Interface (SPEAKER)
This interface uses a mini-pin jack-type connector.
CF Card Interface
This interface accepts a CF Card, and uses an IDE connection
CD-ROM Drive Interface
This interface is used to connect Digital's CD-ROM Drive unit (PSS-CD01).
6

Installation

Confirm the Installation Gasket's Positioning
It is strongly recommended that you use the installation gasket.
Place the PS-A on a level surface with the display panel facing downward.
Check that the PS-A's installation gasket is seated securely into the gasket's
groove, which runs around the perimeter of the panel's frame.
• Before installing the PS-A
installation gasket is securely attached to the unit.
• A gasket which has been used for a long period of time may have
scratches or dirt on it, and could have lost much of its water resis-
tance. Be sure to change the gasket at least once a year, or when
scratches or dirt become visible.
• Be sure to use gasket model CA3-WPG15-01.
• Be sure the gasket's seam is not inserted into any of the unit's cor-
ners, only in the straight sections of the groove. Inserting it into a
corner may lead to its eventually tearing.
• To ensure the installation gasket's maximum level of moisture resis-
tance, be sure the gasket's seam is inserted as shown into the
panel's bottom face.
*1 Since an IDE-type connection is used, the unit is not hot-swappable. When removing the unit,
be sure that power is turned OFF.
unit
into a cabinet or panel, check that the
Rear of PS-A unit
Gasket
*1
.
E-13