Tools And Materials Required - Profile Design WING/20c Instructions Manual

INTRODUCTION
Thank you for purchasing this Profile Design Basebar. These instructions apply to the basebars listed below, combined with any Profile Design clip
on aerobar and stem:
• WING/20
C
• WING/
C
• WING/10
A
• WING/
A
• OZERO TT
Please read these instructions thoroughly before attempting to install this item. Proper installation is required for compliance with Profile Design's
warranty policy. If you are not familiar with installation of Aerobars or their accessories, please seek the assistance of your local Profile design dealer by
logging on to www.profile-design.com and using "dealer search" or by calling Profile Design's customer service number p.# 888.800.5999.
Note to Dealers: If you install this product for the consumer, please provide him/her with this owner's manual after installation.

Tools and materials required:

• 5mm Hex Wrench
• 4mm Hex Wrench
• Torque Wrench for a 5mm and 4mm Hex fitting
• Assembly compound such as Finishline Fiber Grip™
• Grease such as Finishline Premium Grease
• Threadlocker such as Loctite® Threadlocker Blue 242®
• Cutting guide
Basebar
1